Code: 200.27
Description: Printhead Driver: Mirror motor fell out of lock condition after the media at the input sensor–more time elapsed since the printhead than the expected stable lock time, but less than the printhead jitter-stable specification. Mirror motor fell out of lock condition after media at the input sensor–more time elapsed since the printhead than expected stable lock time, but less than the printhead jitter-stable specification.
Remedy: Printhead Note: New printhead must be aligned. See “Printhead assembly electronic adjustment”. Turn the printer off. Disconnect the printhead cables from J12 and J8 on the controller board. Turn the printer on with the front door closed. On the controller board, verify +5 V dc on pin 10 at J12 and +5 V dc on pins 1, 2, and 3 at J8. Verify grounds on pins 2, 4, and 7 at J12 and on pin 4 at J8. •If voltages or grounds are incorrect, then check the controller board. See “Controller board service check” for more information. •If voltages are correct, then replace the printhead (comes with cables).