Code: 927.00
Description: Service fan error
Remedy: Replace the fan
Make sure the fan cable plug is properly seated at J13 (controller board). Turn the printer on. Within a few seconds, the controller board assembly should apply +24 V dc to pin 2. •If voltage is not present, then check or replace the controller board. See “Controller board removal”. •If voltage is present, then check pin 1 for 24 V dc as well. If it is close to 24 V dc while the fan is still idle, then replace the fan. See “Fan removal”.
Make sure the fan cable plug is properly seated at J13 (controller board). Turn the printer on. Within a few seconds, the controller board assembly should apply +24 V dc to pin 2. •If voltage is not present, then check or replace the controller board. See “Controller board removal”. •If voltage is present, then check pin 1 for 24 V dc as well. If it is close to 24 V dc while the fan is still idle, then replace the fan. See “Fan removal”.