Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi 231.00...234.01 — Lexmark X466de

Code: 231.00...234.01

Description: 231.00 Duplex jam while reversing into the device 231.01 Duplex sensor never made by leading edge reversing into the duplex. 231.02 Bouncy duplex sensor never made. 232.00 Duplex jam while staging in the device 232.01 Duplex sensor never broke by the sheet ahead after reversing into the duplex. 232.02 Page in duplex ahead of current reversing page never staged. 233.00 Duplex jam while picking from the device 233.01 Page in duplex never picked. 233.02 Feed error picking from the duplex. 233.03 Paper never reached the input sensor, but was detected at the manual feed sensor. 234.01 Duplex sensor covered during warm-up.
Remedy: Open the rear cover and look for obstructions between the rear cover ribs, the fuser exit rollers, and below. The media entering the duplex passes outside the exit roller while the media exiting the fuser passes above and inside the exit rollers. Remove the tray, open the duplex door, and remove the obstructions. If there are no obstructions and the problem persists, then disconnect all of the cables, tilt the printer onto its back (be sure to protect the antenna on a wireless unit), and inspect the flag of the duplex sensor. If the flag does not rotate freely, then replace the paper input and duplex sensor. See “Paper input and duplex sensor assembly removal”. Check the belt and drive of the duplex unit. Replace it if necessary.

← Xem tất cả mã lỗi Lexmark X466de

Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie