Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi 294.04, 294.05, 294.06 — Lexmark X466de

Code: 294.04, 294.05, 294.06

Description: 294.04 Scanner jam, remove all originals from the scanner. Jam at the ADF exit sensor. 294.05 Scanner jam, remove all originals from the scanner. A jam is detected at the ADF exit sensor. 294.06 ADF Backfeed Jam. A jam is detected at the ADF exit sensor.
Remedy: 1 If the ADF is multi-feeding, check for dirt on the ADF separator pad and ADF separator rollers. Are they dirty? Clean them with a lint free cloth and isopropyl alcohol. Replace the separator pad and ADF pick roll. 2 If the paper is skewing when it is fed into the ADF, check the paper guide width. Is it set correctly? Go to step 3. Set the paper guides so they contact the edges of the paper. 3 If paper is skewing when fed or jamming check to see if the top cover is open or ajar. Is the ADF top cover open or ajar? Properly close the top cover. If the paper is jamming in the ADF, go to step 6. 4 Is paper failing to feed into the ADF? Go to step 5. There is no issue. 5 Perform the ADF paper present, scan 1st and scan 2nd sensor tests. See “Scanner Tests”. Are the sensors working properly? Go to step 6. Go to step 9. 6 Check the leading edge of the paper to ensure the paper is not curled or bent in a way that would keep it from contacting the paper present sensor actuator. Is the paper damaged? Bad media. Go to step 7. 7 Is there dirt in the sensors, or is the paper present actuator stuck? Clean the sensors, or remove debris from the actuators. Go to step 8. 8 Are the sensor actuators on the ADF mechanism cover damaged? Replace the ADF. Go to step 9. 9 Is the ADF connector properly connected to J4 on the controller board? Go to step 10. Properly connect the cable to the controller board. 10 Inspect the connections on the ADF relay card in the ADF. Are all the connections properly connected? Go to step 11. Secure all the connections. 11 Check the ADF cable for continuity. Is there continuity? Go to step 12. Replace the ADF cable. 12 Check for signals or voltages from J4 on the controller board. Pin 11 and 12 should measure +24VDC. Pin 5 should measure +14VDC. Are there signals or voltages present? Replace the ADF unit. See “ADF removal”. Replace the controller board. See “Controller board removal”.

← Xem tất cả mã lỗi Lexmark X466de

Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie