Code: 843.01
Description: Scanner failure ADF mechanical failure.
Remedy: 1 If the ADF is multi-feeding, check for dirt on the ADF separator pad and ADF separator rollers. Is there dirt present? Clean them with a lint free cloth and isopropyl alcohol. Replace the separator pad and ADF pick roll. 2 If the paper is skewing when it is fed into the ADF, check the paper guide width. Is it set correctly? Go to step 3. Set the paper guides so they contact the edges of the paper. 3 If paper is skewing when fed or jamming check to see if the top cover is open or ajar. Is the ADF top cover open or ajar? Properly close the top cover. If the paper is jamming in the ADF, go to step 6. 4 Is paper failing to feed into the ADF? Go to step 5. There is no issue. 5 Perform the ADF paper present, scan 1st and scan 2nd sensor tests. “SCANNER TESTS”. Are the sensors working properly? Go to step 6. Go to step 9. 6 Check the leading edge of the paper to ensure the paper is not curled or bent in a way that would keep it from contacting the paper present sensor actuator. Is the paper damaged? Bad media. Go to step 7. 7 Is there dirt in the sensors, or is the paper present actuator stuck? Clean the sensors, or remove debris from the actuators. Go to step 8. 8 Are the sensor actuators on the ADF mechanism cover damaged? Replace the ADF. Go to step 9. 9 Is the ADF connector properly connected to JADF1 on the RIP board? Go to step 10. Properly connect the cable to the RIP board. 10 Inspect the connections on the ADF relay card in the ADF. Are all the connections properly connected? Go to step 11. Secure all the connections. 11 Check the ADF cable for continuity. Is there continuity? Go to step 11. Replace the ADF cable. 12 Check for signals or voltages from JADF1 on the RIP board. Pins 11 and 12 should measure +24 V dc. Pin 5 should measure +14 V dc. Are there signals or voltages present? Replace the ADF unit. See “Duplex ADF removal”. Replace the RIP board. Go to “RIP board removal”.