Code: 106.xx
Description: Service Yellow Printhead Yellow printhead error. 106.01 Service Yellow Printhead The yellow printhead lost HSYNC. 106.02 Service Yellow Printhead The yellow printhead failed to complete servo. 106.03 Service Yellow Printhead The yellow printhead mirror motors failed to achieve lock. 106.04 Service Yellow Printhead The yellow printhead mirror motors lost PLL motor lock. 106.05 Service Yellow Printhead Failure reading NVRAM from printhead 106.08 Service Yellow Printhead The yellow laser showed bad in EMS testing. 106.11Service Yellow Printhead Failure writing data to printhead 106.12 Service Yellow Printhead Failure reading data from the printhead 106.13 Service Yellow Printhead Printhead declared error
Remedy: 1 Turn the printer off, and remove the rear shield. See “Rear shield removal”. Check the cable at JMIRR1 for proper connection to the RIP board, the printhead cable for pinch points, and the cable or connector for any other damage. Is the cable damaged? Replace the printhead. See “Printhead removal”. Go to step 2. 2 Turn the printer on, and verify the following values at JMIRR1: Are the values approximately correct? Replace the printhead. See “Printhead removal”. Replace the RIP board See “RIP board removal”.