Code: 109.xx
Description: Service Black Printhead Black printhead error 109.01 Service Black Printhead The black printhead lost HSYNC. 109.02 Service Black Printhead The black printhead failed to complete servo. 109.03 Service Black Printhead The black printhead mirror motors failed to achieve lock. 109.04 Service Black Printhead The black printhead mirror motors lost PLL motor lock. 109.05 Service Black Printhead Failure reading NVRAM from printhead. 109.08 Service Black Printhead The black laser showed bad in EMS testing. 109.11Service Black Printhead Failure writing data to printhead. 109.12 Service Black Printhead Failure reading data from the printhead. 109.13 Service Black Printhead Printhead declared error.
Remedy: 1 Turn the printer off, and remove the rear shield. See “Rear shield removal”. Check the cable at JMIRR1 for proper connection to the RIP board, the printhead cable for pinch points, and the cable or connector for any other damage. Is the cable damaged? Replace the printhead. See “Printhead removal”. Go to step 2. 2 Turn the printer on, and verify the following values at JMIRR1: Are the values approximately correct? Replace the printhead. See “Printhead removal”. Replace the RIP board See “RIP board removal”.