Code: 107.xx
Description: Cyan Printhead Error Cyan printhead error 107.01 Service Cyan Printhead The cyan printhead lost HSYNC. 107.02 Service Cyan Printhead The cyan printhead failed to complete servo. 107.03 Service Cyan Printhead The cyan printhead mirror motors failed to achieve lock. 107.04 Service Cyan Printhead The cyan printhead mirror motors lost PLL motor lock. 107.05 Service Cyan Printhead Failure reading NVRAM from the cyan printhead 107.08 Service Cyan Printhead The cyan laser showed bad in EMS testing. 107.11Service Cyan Printhead Failure writing data to printhead 107.12 Service Cyan Printhead Failure reading data from the printhead. 107.13 Service Cyan Printhead Printhead declared error.
Remedy: 1 Turn the printer off, and remove the rear shield. See “Rear shield removal”. Check the cable at JMIRR1 for proper connection to the RIP board, the printhead cable for pinch points, and the cable or connector for any other damage. Is the cable damaged? Replace the printhead. See “Printhead removal”. Go to step 2. 2 Turn the printer on, and verify the following values at JMIRR1: Are the values approximately correct? Replace the printhead. See “Printhead removal”. Replace the RIP board See “RIP board removal”.