Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi 200.09 — Lexmark X644

Code: 200.09

Description: Did not receive proper motor feedback to start laser servo. Motor connections
Remedy: 1 Main drive assembly (excessive noise or vibration) Remove the controller board and run a Diagnostic Print Test in the continuous mode. Check the main drive assembly for any excessive noise or vibration. Determine if the noise is in the main drive, toner cartridge, fuser, or main drive gearbox. Look for any loose or worn parts in the developer drive assembly, main drive gearbox, or fuser. Repair as necessary. 2 Main drive motor assembly (excessive noise, gears ratcheting and so on) A service error code 936 - Transport Motor may be displayed. Check the voltage at J20-6 on the system board. It measures approximately +5 V dc when the motor is not running and goes to 0 V dc when the motor is running. If incorrect, replace the system board. If this does not fix the problem, replace the main drive motor. 3 Main drive motor cable Check the continuity of the main drive motor cable. If incorrect, replace the cable. 4 Motor gear does not turn, no 936 error code or 201.xx Paper Jam user message displays. Check the voltages at J20 on the system board. J20-11 +24 V dc J20-8 +5 V dc 0 V dc J20-7 +5 V dc 0 V dc J20-6 +5 V dc +2.5 V dc J20-5 +5 V dc 0 V dc J20-4 +5 V dc +5 V dc J20-1 +5 V dc 0 V dc If the voltage is incorrect, replace the FRUs in the following order: • Main drive motor assembly • System board

← Xem tất cả mã lỗi Lexmark X644

Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie