Remedy: Replace the operator panel right cover assembly. See “Operator panel right cover assembly removal”. Warning: When replacing any one of the following components: • Operator panel right cover assembly • System board assembly • Interface card assembly Only replace one component at a time. Replace the required component, and perform a POR before replacing a second component listed above. If this procedure is not followed, the printer will be rendered inoperable. Never replace two or more of the components listed above without a POR after installing each one, or the printer will be rendered inoperable. Warning: Never install and remove components listed above as a method of troubleshooting components. Once a component has been installed in a printer, it cannot be used in another printer. It must be returned to the manufacturer.