Code: 930.00...936.00
Description: 930 .00 An incorrect printhead has been detected Check the printhead 932 .00 Printhead lost HSYNC. • Check printhead • Check cables and connections • Check system board 933 .00 Mirror motor locked, no first HSYNC received. • Check printhead • Check cables and connectors • Check system board. 934 .00 Mirror motor lost lock • Check printhead • Check cables and connections • Check system board 936 .00 Mirror moor not up to speed • Check printhead • Check system board
Remedy: 1 Error code 931.xx No first HYSNC Signal Error Code 932 Lost HYSNC These errors usually indicate a failure in the HYSNC signal to the printhead. Check the continuity of the cables connected to J2 and J4 on the system board. If incorrect, replace the defective cable. The voltage at J4-1 measures approximately +5 V dc. If incorrect, replace the system board. The voltage at J2-7 measures approximately +24 V dc. If incorrect, replace the system board. If correct, replace the printhead assembly. See “Printhead removal”. 2 Error Code 934.xx Mirror motor lost lock Error Code 935 Mirror motor unable to reach operating speed These error codes indicate a problem with the mirror motor circuit in the printhead assembly or the mirror motor cable to the system board cable or system board assembly. The voltage at J5-2 measures approximately +24 V dc. If incorrect, replace the system board. If correct, replace the FRUs in the following order: • System board. See “System board and inner shield removal— model X642e” or “System board and inner shield removal —models X644e/X646e”. • Printhead assembly See “Printhead removal”.