Description: POST Error Tray 1 motor not connected.
Remedy: 1 1. Turn the printer off. 2. Remove the rear frame cover. See “Rear frame cover removal”. 3. Check the cable in connector JFDPCK1 for proper connection to the system board, the cable for pinch points, and the cable or connector for any other damage. 4. Reseat the cable. 5. POR the printer. Did the error clear? Problem resolved. Go to step 2. 2 Measure the continuity across all of the fuses on the system board. Are any of the fuses blown? Replace the system board. See “System board removal”. Go to step 3. 3 1. Disconnect the cable in connector JFDPCK1, and then connect the cable for the new paper pick mechanism. 2. Enter Diagnostics mode (press and hold buttons 3 and 6, turn on the MFP, and release the buttons when the progress bar displays). 3. Touch MOTOR TESTS. 4. Touch Tray 1. Did the new pick motor turn before the feed error occur? Replace the paper pick mechanism. See “Paper pick mechanism assembly removal”. Replace the system board. See “System board removal”.