Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi 920.08 — Lexmark X734

Code: 920.08

Description: POST Error Exit sensor not connected.
Remedy: 1 Verify the paper is loaded properly in the paper tray or manual feed slot. Is the paper properly loaded? Go to step 2. Load paper correctly. 2 1. Turn the printer off. 2. Install the new fuser. See “Fuser assembly removal”. Note: Do not reset fuser count or run motor calibration yet. 3. POR the printer. Did the error clear? Problem resolved. Note: Complete the fuser installation, reset fuser count, and run motor calibration. See “Fuser assembly removal”. Remove the new fuser, and go to step 3. 3 Remove the rear frame cover. See “Rear frame cover removal”. Check the fuser DC cable in the connector JFUSER1 for proper connection to the system board, for pinch points, and for any other damage to the cable or the connector. Is the cable damaged? Replace the fuser DC cable. See “Fuser DC cable removal”. Go to step 4. 4 Place a voltmeter between the fuser DC autoconnect pin 8 and ground (pin 6). Does the meter rear +5 V dc? Go to step 6. Go to step 5. 5 Place a voltmeter between the connector JFUSER1 pin 8 and ground (pin 6) on the system board. Does the meter read +5 V dc? Go to step 6. Replace the fuser DC cable. See “Fuser DC cable removal”.

← Xem tất cả mã lỗi Lexmark X734

Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie