Remedy: 1 1. Turn off the printer. 2. Remove the rear frame cover. See “Rear frame cover removal”. 3. Check JPH1 and JTPS1 for proper connection and damage. 4. Check the transport cable on the transfer belt module side for any damage. Is either of the cables damaged? If the JTPS1 cable is damaged, replace the JTPS1 cable. If the JPH1 cable is damaged, replace the printhead assembly. See “Printhead removal, installation, and adjustment” Go to step 2. 2 1. Reseat the JPH1 and JTPS1 cables. 2. Reseat the transport cable on the transfer belt module side. 3. Power on the printer. Does the problem persist? Go to step 3. Problem resolved. 3 Install a new transfer module to verify if the old transfer module is defective. Does the problem persist? Go to step 4. Replace the transfer module. See “Transfer module removal”. 4 Connect a new transport cable from outside of the machine. Does the problem persist? 1. Return the old transfer module and transport cable. 2. Go to step 5. Replace the transport cable. See “Transport cable removal”. 5 Connect a new printhead assembly from outside of the printer and verify the printhead. See “Printhead verification”. Does the problem persist? Replace the system board. See “System board removal”. Replace the printhead assembly. See “Printhead removal, installation, and adjustment”