Description: POST Error Duplex motor is not connected.
Remedy: 1 1. Turn the printer off. 2. Remove the rear frame cover. See “Rear frame cover removal”. 3. Reseat the cable in connector JDX1. Did the error clear? Problem resolved. Go to step 2. 2 Measure the continuity across all of the fuses on the system board. Are any of the fuses blown? Replace the system board. See “System board removal”. Go to step 3. 3 1. Remove the right cover. See “Right cover removal”. 2. Check the MPF/duplex motor cable in connector JDX1 for pinch points and any other damage to the cable or connector. Check both ends of the cable. Is the cable damaged? Replace the MPF/duplex motor cable. See “Multipurpose feeder (MPF)/duplex motor cable removal”. Note: Make sure to verify if the new cable is working properly first. Route the cables properly only when you have verified that the cables are working properly. Go to step 4. 4 1. Replace the MPF/duplex motor assembly. See“Multipurpose feeder (MPF)/duplex motor cable removal”. Note: Before replacing a motor, always verify if the new part is working properly by connecting it outside of the machine, 2. POR the printer and check if the error is gone. Did the error clear? Problem resolved. Replace the system board. See “System board removal”.