Remedy: 1 1. Turn the printer off. 2. Remove the rear frame cover. See “Rear frame cover removal”. 3. Check the cables in connectors JCARTP1 and JCARTS1 (cartridge motor 1/fuser motor cable) for proper connection to the system board, for cable pinch points, and for any other damage to the cable or connectors. Is either cable damaged? Go to step 3. Go to step 2. 2 1. Remove the right cover. See “Right cover removal”. 2. Check the cartridge motor 1/fuser motor cable for proper connection to the EP drive assembly, for pinch points for the cable, and for cable or connector damage. Is either cable damaged? Go to step 3. Go to step 4. 3 Replace the cartridge motor1/fuser motor cable. See “Cartridge motor 1/fuser cable removal”. Note: Make sure to check the replacement cable first before installation, leaving the original cable in place. Make sure to verify if the new cable is working properly. If new cable does not correct problem, do not install it. Did the error clear? Problem solved Go to step 4. 4 Measure the continuity across all of the fuses on the system board. Are any of the fuses blown? Replace the system board. See “System board removal”. Go to step 5. 5 1. Plug the cartridge motor1/fuser motor cable to a new EP drive assembly. 2. Bring the printer up in Diagnostics Menu (Turn off the printer, press and hold buttons 3 and 6, then turn on the printer). 3. Touch MOTOR TESTS. 4. Touch Tray 1. Did the error clear? Replace the EP drive assembly. See “Electrophotographic (EP) drive assembly removal”. replace the system board. See “System board removal”.