Description: POST Error Cartridge motor 2 (middle) is not connected.
Remedy: 1 1. Turn the printer off. 2. Remove the rear frame cover. See “Rear frame cover removal”. 3. Reseat the cables in connector JCARTP2 and JCARTS2. Did the error clear? Problem resolved. Go to step 2. 2 Check the cable in connector JCARTP2 and JCARTS2 for pinch points and any other damage to the cable or connector. Are the cables damaged? Replace the cartridge motor 2/3 cable. See “Cartridge motor 2/3 cable removal”. Go to step 3. 3 1. Remove the right cover. See “Right cover removal”. 2. Check the cartridge motor 2/3 cable (A) for the proper connection to the EP drive assembly, pinch point for the cable, or damage to the cable or connectors. Is either cable (A) damaged? Replace the cartridge motor 2/3 cable. See “Cartridge motor 2/3 cable removal”. Go to step 4. 4 Measure the continuity across all of the fuses on the system board. Are any of the fuses blown? Replace system board. See “System board removal”. Go to step 5. 5 Connect a new cartridge motor 1/fuser cable from the outside of the machine. Did the error clear? Replace the cartridge motor 1/fuser cable. See “Cartridge motor 1/fuser cable removal”. Go to step 6. 6 Connect the old cartridge motor 1/fuser motor cable to a new EP drive assembly outside of the machine. Did the error clear? Replace the EP drive assembly. See “Electrophotographic (EP) drive assembly removal”. Replace system board. See “System board removal”.