Description: POST Error Input sensor not connected.
Remedy: 1 Is the input sensor flag damaged? Replace the paper pick mechanism. See “Paper pick mechanism assembly removal”. Go to step 2. 2 1. Turn the printer off. 2. Remove the rear frame cover. See “Rear frame cover removal”. 3. Check the cable in connector JTRAY1 for proper connection to the system board, for pinch points, and any other damage to the cable or connector. Check both ends of the cable. Is the cable damaged? Replace the paper pick mechanism. See “Paper pick mechanism assembly removal”. Go to step 3. 3 1. Disconnect the cable in the connector JTRAY1. 2. Connect the cable from the new paper pick assembly in connector JTRAY1. 3. Enter Diagnostics mode (press and hold buttons 3 and 6, turn on the MFP, and release the buttons when the progress bar displays). 4. Touch SENSOR TESTS. 5. Touch Dynamic Sensors. 6. Touch Input. 7. Activate the input sensor. Did the touchscreen change from Open to Closed? Replace the paper pick mechanism. See “Paper pick mechanism assembly removal”. Replace the system board. See “System board removal”.