Description: POST Error Top access cover sensor not connected.
Remedy: 1 Open the top access cover. Is the top cover sensor damaged? Replace the top cover sensor. Go to step 2. 2 1. Turn the printer off. 2. Remove the rear frame cover. See “Rear cover removal”. 3. Check the cable in the connector JFDS1 for proper connection to the system board, pinch points, and the cable or connector for any other damage. Is the cable damaged? Replace the top cover sensor. Go to step 3. 3 1. Disconnect the cable in connector JFDS1. 2. Connect the new top cover sensor. 3. Enter Diagnostics mode (press and hold buttons 3 and 6, turn on the MFP, and release the buttons when the progress bar displays. 4. Touch Sensor Tests. 5. Touch Dynamic Sensors. 6. Touch Top Door. 7. Activate the top cover sensor by pressing the flag as shown. Does the display on the touchscreen change from Open to Closed? Replace the top cover sensor. Replace the system board. See “System board removal”.