Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi 920.21 — Lexmark X738dte

Code: 920.21

Description: POST Error +24 V power supply failure.
Remedy: 1 Note: The LVPS must be turned off for several seconds before turning back on. This error can occur if the LVPS does not have time to recover after being turned off. 1. Open the front door cover 2. Check the 24V interlock switch for damage and proper installation. 3. Check if the front door actuator can trigger the sensor. Is the front door sensor actuator able to trigger the sensor? Go to step 3. Go to step 2. 2 1. Check if the front door assembly can close properly. 2. Check the front door pivot for any damage. 3. Check if the front door can close properly. Is the front door damaged? Replace the front door. See “Front door assembly removal”. Go to step 3. 3 1. Check the cable in connector JCVR1 for proper connection to the system board, pinch points, and for any other damage to the cable or connector. 2. Reseat the cable. Did the error clear? Problem resolved. Go to step 4. 4 1. Disconnect the cable in connector JCVR1 2. Connect a new 24 V interlock switch without properly routing the cables. Note: The 24V interlock switch should be plugged in without installing inside the machine. Close the covers, manually actuate the switch, and then turn on the machine. Did the error clear? Replace the 24 V interlock switch. See “24 V interlock switch removal”. Go to step 5. 5 Check the input voltage switch on the back of the low-voltage power supply (LVPS). Some power supplies do not have the switch. Note: If your FRU does not have a switch, proceed to step 6. Is the voltage level (115/230) properly set? Go to step 6. Set the switch for the proper voltage supported by your country. 6 Reseat the cable in connector JLVPS1. Did the error clear? Problem resolved. Go to step 7. 7 Replace the LVPS. Note: Verify first if the new LVPS is working properly before installing it inside the machine. Remove the old LVPS, and install the new LVPS without installing the screws. Connect the fuser and JLVPS1 connectors to the new LVPS. Did the error clear? Replace the LVPS. See “Low-voltage power supply (LVPS) removal”. Replace the system board. See “System board removal”.

← Xem tất cả mã lỗi Lexmark X738dte

Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie