Description: POST Error Narrow media sensor not connected.
Remedy: 1 1. Turn the printer off. 2. Remove the rear frame cover. See “Rear frame cover removal”. 3. Reseat the cable in connector JTRAY1. Did the error clear? Problem resolved. Go to step 2. 2 Check the cable in connector JTRAY1 for pinch points and the cable or connector for any other damage. Is the cable damaged? Replace the paper pick mechanism. See “Paper pick mechanism assembly removal”. Go to step 3. 3 Place a voltmeter between JTRAY1 pin 4 and ground (pin 1). Does the meter read +5 V dc? Go to step 4 Replace the system board. See “System board removal”. 4 1. Disconnect the cable in JTRAY1, and connect the cable from the new paper pick mechanism. 2. Enter Diagnostics mode (press and hold buttons 3 and 6, turn on the MFP, and release the buttons when the progress bar displays. 3. Touch Sensor Tests. 4. Touch Dynamic Sensors. 5. Touch Narrow Media. 6. Activate the narrow media sensor. Did the narrow media sensor change from Closed to Open on the touchscreen? Replace the paper pick mechanism. See “Paper pick mechanism assembly removal”. Replace the system board. See “System board removal”.