Description: 925.01 Fan Error Fan has stalled. 925.03 Fan Error Fan has stalled. 925.05 Fan Error Fan has stalled.
Remedy: 1 1. Turn the printer off. 2. Remove the rear frame cover. See “Rear frame cover removal”. 3. Check the cable in connector JFAN1 for proper connection to the system board, for pinch points, and for any other damage to the cable or the connector. Is the cable damaged? Replace the fan. See “Cooling fan removal”. Go to step 2. 2 Measure the continuity across all of the fuses on the system board. Are any of the fuses blown? Replace the system board. See “System board removal”. Go to step 3. 3 1. Disconnect the cable in connector JFAN1, and install a new cooling fan. 2. Turn the multifunction printer off, and turn the MFP on (perform a POR). Note: After installing the new fan, a print test is required to verify operation. Print one page every 30 seconds for 20 minutes to test the highest fan speed. Do not test unless the fan is installed in the machine. Did the error clear? Replace the fan. See “Cooling fan removal”. Replace the system board. See “System board removal”.