Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi 950.00 ... 950.29 — Lexmark X748de

Code: 950.00 ... 950.29

Description: NVRAM Failure Mismatch between operator panel assembly NVRAM and system board.
Remedy: 1 Remove all options card from the printer, and then turn on the printer. Does this clear the error? Problem resolved. Go to step 2. 2 Has the top access cover been recently replaced or swapped from other machines? Install a new Top access cover and perform a POR. Warning: Only install a top access cover that was not previously installed on other machines. Go to step 3 3 Has the UICC been recently replaced or swapped from other machines? Install a new UICC card and perform a POR. Warning: Only install a UICC card that was not previously installed on other machines. Go to step 4. 4 Has the system board been recently replaced or swapped from other machines? Install a new System board and perform a POR. Warning: Only install a system board that was not previously installed on other machines. Go to step 5. 5 Turn the printer power off for ten or more seconds. Then turn the power back on (POR the printer). Is the error gone, and can the printer print? Problem resolved. Go to step 6. 6 1. Boot the printer to Configuration Mode by pressing 2 and 6 button during POR. 2. Navigate to Factory Defaults > Restore Base. Note: You will lose printer customer settings. 3. Exit Configuration Mode, and then POR the printer. Does this fix the problem? Problem resolved. Go to step 7. 7 Clear the NVRAM of the printer. 1. Turn the printer power off. 2.With the printer off, press and hold the 2, 6, 7, and 8 buttons. 3. Turn the printer power on. 4.When the message Restoring Factory Defaults displays, release the buttons. If the MFP locks up on the Restoring Factory Defaults message, wait two minutes, and then turn the printer power off. After ten seconds or more, turn the printer power back on without holding down any buttons. Was the NVRAM cleared? Problem resolved. Go to step 8. 8 Replace the UICC card. See “UICC card removal”. Warning: Only install a UICC card that was not previously installed on other machines. Does this fix the problem? Problem resolved. Go to step 9. 9 Replace the system board. See “System board removal”. Warning: Only install a system board that was not previously installed on other machines. Does this fix the problem? Problem resolved. Contact your next level of support.

← Xem tất cả mã lỗi Lexmark X748de

Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie