Code: 80
Description: Scheduled maintenance Scheduled maintenance required Service is required to maintain printer performance.
Remedy: The LCD displays 80 scheduled maintenance at each 300K page count interval. It is necessary to replace the fuser assembly, transfer roller, and feed, pick and separation rollers at this interval to maintain the print quality and reliability of the printer. The parts are available as a maintenance kit with the following part numbers: 40X0394—Maintenance Kit, 110 V 40X0398—Maintenance Kit, 220 V 40X2377—Maintenance Kit, 100 V The ADF requires scheduled maintenance at each 150K page count interval. It is necessary to replace the feed/ pick roll assembly and the separation guide assembly at this interval to maintain ADF media feed reliability. The parts are available as a maintenance kit with the following part number: 40X2734—Maintenance Kit, ADF After replacing the kit, the maintenance count must be reset to zero to clear the “80 scheduled maintenance” message. To reset the maintenance count 1. Turn off the printer 2. Press and hold the 2 and 6 buttons simultaneously. 3. Turn on the printer. 4. Release the buttons after 10 seconds. The Configuration Menu appears on the LCD. 5. Touch Reset Maintenance Counter from the Configuration Menu. 6. Reset Maintenance Counter appears in the header and Yes and No appears below the header. 7. To cancel the reset operation, press Back or No. All other button presses are ignored. 8. To initiate the reset operation, select Yes. The maintenance count resets to zero and the LCD returns to the Configuration Menu. When performing the 300K scheduled maintenance procedure, the following areas should be cleaned of media dust and toner contamination: • Media trays • PC cartridge area • Transfer roll area • Duplex area • Exit 2 area • Standard bins • Bridge unit area (if equipped) • Finisher media bins (if equipped)