Description: Service PC cartridge Sensor (K ATC) Outputs of the sensor (K ATC) are not in the specified range. This error must be reset inside diagnostic mode before troubleshooting or machine operation can occur.
Remedy: 1 Reset the K ATC failure lock out condition. 1. Enter diagnostic mode 2. Touch Dev unit reset. 2. Touch K channel Perform a very large print test. Does the error continue? Go to step 2. Problem solved. 2 Check the sensor (K ATC) for proper connection. Is the above component properly connected? Replace the K Developer unit assembly. Go to “Developer unit assembly removal”. Replace the connection. 3 Perform a very large print test. Does the error continue? Replace the upper printer engine card assembly. Go to “Upper printer engine card assembly removal”. Problem solved.