Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi 120 — Lexmark XC4150

Code: 120

Description: 120.80 The motor (fuser) did not turn on. 120.81 The motor (fuser) did not turn off. 120.82 The motor (fuser) speed did not ramp up to the required level. 120.83 The motor (fuser) stalled. 120.84 The motor (fuser) ran too slow. 120.85 The motor (fuser) ran too fast. 120.86 The motor (fuser) did not run at the correct timing.
Remedy: Step 1 Reset the printer. Does the problem remain? Go to step 2. The problem is solved. Step 2 Check the fuser for damage or life expiration, and replace if necessary. See “Fuser removal”. Does the problem remain? Go to step 3. Go to step 4. Step 3 Check the motor cable on the JFUSED1 connector on the controller board for proper connection. Is the cable properly connected at both ends? Go to step 5. Go to step 4. Step 4 Reconnect the cable. Does the problem remain? Go to step 5. The problem is solved. Step 5 Check the cable for damage, and replace if necessary. Does the problem remain? Go to step 6. The problem is solved. Step 6 Remove the fuser, and then manually turn the fuser drive gear. Does the gear freely turn? Go to step 8. Go to step 7. Step 7 Replace the fuser drive gear. Does the problem remain? Go to step 8. The problem is solved. Step 8 Replace the motor (fuser). See “Motor (fuser) removal”. Does the problem remain? Go to step 9. The problem is solved. Step 9 Replace the controller board. See “Controller board removal”. Does the problem remain? Contact the next level of support. The problem is solved.

← Xem tất cả mã lỗi Lexmark XC4150

Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie