Code: 242.x4
Description: 242.24 Paper fed from tray 2 cleared the sensor (tray 2 pass-through) or the sensor (tray 2 trailing edge) earlier than expected 242.34 Paper fed from tray 3 cleared the sensor (tray 2 pass-through) or the sensor (tray 2 trailing edge) earlier than expected. 242.44 Paper fed from tray 4 cleared the sensor (tray 2 pass-through) or the sensor (tray 2 trailing edge) earlier than expected. 242.94 Paper cleared the sensor (tray 2 pass-through) or the sensor (tray 2 trailing edge) earlier than expected. Paper source is undetermined.
Remedy: Step 1 a From the home screen, touch Settings > Device > Preferences. b Check if the paper size matches the size set on the tray guides. Does the paper size match the size set on the tray? Go to step 3. Go to step 2. Step 2 Change the paper size or adjust the size setting in the tray. Does the problem remain? Go to step 3. The problem is solved. Step 3 Check if the paper size matches the size set on the tray guides. Does the paper size match the size set on the tray? Go to step 5. Go to step 4. Step 4 Replace the paper or change the paper size setting in the tray. Does the problem remain? Go to step 5. The problem is solved. Step 5 Check the paper tray for overfilling. Is the paper tray overfilled? Go to step 6. Go to step 7. Step 6 Remove the excess paper from the tray. Does the problem remain? Go to step 7. The problem is solved. Step 7 Check the paper condition in the tray. Is the paper crumpled or damaged? Go to step 8. Go to step 9. Step 8 Replace the crumpled or damaged paper. Does the problem remain? Go to step 9. The problem is solved. Step 9 a Enter the Diagnostics menu, and then navigate to: Additional input tray diagnostics > Sensor tests b Find the sensor (Trailing edge (tray [x])). Does the sensor status change while toggling the sensor? Go to step 12. Go to step 10. Step 10 Reseat the sensor cable, and then check the sensor for misalignment and damage. Is the sensor properly installed and free of damage? Go to step 12. Go to step 11. Step 11 Reinstall or replace the sensor. See “Sensor (550-sheet tray trailing edge) removal”. Does the problem remain? Go to step 12. The problem is solved. Step 12 a Enter the Diagnostics menu, and then navigate to: Additional input tray diagnostics > Sensor tests b Find the sensor (Pass-through (tray [x])). Does the sensor status change while toggling the sensor? Go to step 15. Go to step 13. Step 13 Reseat the sensor cable, and then check the sensor for misalignment and damage. Is the sensor properly installed and free of damage? Go to step 15. Go to step 14. Step 14 Reinstall or replace the sensor. See “Sensor (550-sheet tray passthrough) removal”. Does the problem remain? Go to step 15. The problem is solved. Step 15 Perform a print test. Does the problem remain? Contact the next level of support. The problem is solved.