Code: 202.31
Description: Media remains on the sensor (narrow media) during the warm.up sequence
Remedy: Step 1 Check the fuser for jammed media. Is the fuser path free from jammed media? Go to step 2. Remove any jammed media.
Step 2 Check the sensor (fuser exit) for proper operation. a Enter the diagnostic mode. b Select Base sensor test. c Observe the line item fuser exit. Does the display on the control panel change every time the sensing area of the above sensor is interrupted or blocked? Go to step 4. Go to step 3.
Step 3 Check the above sensor for proper connection. Is the above sensor connected properly? Replace the fuser. See “Fuser removal”. Go to step 4. Reseat the connection. Go to step 4.
Step 4 Perform a print test. Does the problem remain? Contact the next highest level of technical support. Problem solved.
Step 2 Check the sensor (fuser exit) for proper operation. a Enter the diagnostic mode. b Select Base sensor test. c Observe the line item fuser exit. Does the display on the control panel change every time the sensing area of the above sensor is interrupted or blocked? Go to step 4. Go to step 3.
Step 3 Check the above sensor for proper connection. Is the above sensor connected properly? Replace the fuser. See “Fuser removal”. Go to step 4. Reseat the connection. Go to step 4.
Step 4 Perform a print test. Does the problem remain? Contact the next highest level of technical support. Problem solved.