Code: 190.10
Description: The elevator plate did not move to the correct position.
Remedy: Step 1 a Make sure that the tray is properly installed and aligned to the printer. b Reseat the interface cable that is plugged into the 2500. or 2 x 500.sheet tray. c Reset the printer. Does the problem remain? Go to step 2. The problem is solved. Step 2 Enter the Diagnostics menu, and then navigate to: MOTOR TESTS > 3000.Sheet Tray Motor Test > Tray elevator Does the motor run? Go to step 4. Go to step 3. Step 3 a Make sure that the motor (3000-sheet tray elevator) is properly installed. b Reseat the cable on the motor and the cable CN3 on the controller board. c Check the motor for damage, and replace if necessary. See gMotor (3000-sheet tray elevator) removalh. Does the problem remain? Go to step 4. The problem is solved. Step 4 a Reseat the cable on all of the sensors. b Reseat the cable CN5 on the controller board. c If necessary, reseat all of the junction connectors on the cables. d Make sure that the cables do not block the path of moving parts. e Check the cables for damage, and replace if necessary. Does the problem remain? Go to step 5. The problem is solved. Step 5 a Reseat the cable on the rest of the motors and on the top door switch. b Reseat the cables CN3 and CN4 on the controller board. c If necessary, reseat all of the junction connectors on the cables. d Make sure that the cables do not block the path of moving parts. e Check the cables for damage, and replace if necessary. Does the problem remain? Contact the next level of support. The problem is solved.