Code: 121.80, 121.85
Description: 121.80 The fuser roller did not retract. 121.85 The heating roller did not turn.
Remedy: Step 1 Enter the Diagnostics menu, and then navigate to: PRINTER SETUP > Reset Engine Service Error Does the problem remain? Go to step 2. The problem is solved. Step 2 a Remove the fuser. See “Fuser removal”. b Observe the fuser roller while moving the gears and levers engaged to it. Check if the roller properly retracts, and replace if necessary. Does the problem remain? Go to step 3. The problem is solved. Step 3 Check the sensor (fusing pressure home). Is it free of damage? Go to step 4. Go to step 6. Step 4 Enter the Diagnostics menu, and then navigate to: SENSOR TESTS > PRINTER SENSOR TESTS > Fusing pressure home Does the sensor status change while toggling the sensor? Go to step 7. Go to step 5. Step 5 a Reseat the fusing pressure home sensor cable. b Check the cable for damage, and replace if necessary. Does the problem remain? Go to step 6. The problem is solved. Step 6 Replace the sensor (fusing pressure home). Does the problem remain? Go to step 7. The problem is solved. Step 7 a Reseat the fuser cables. b Check the cables for damage, and replace if necessary. Does the problem remain? Go to step 8. The problem is solved. Step 8 a Make sure that the fuser is properly installed. b Check the fuser for wear or damage, and replace if necessary. See “Fuser removal”. Does the problem remain? Go to step 9. The problem is solved. Step 9 Check the engine controller board pins for damage, and replace if necessary. See “Engine controller board removal”. Does the problem remain? Contact the next level of support. The problem is solved.