Code: 242.93
Description: The sensor (tray 2 transport) did not detect the paper from the 3000.sheet tray.
Remedy: Step 1 a Make sure that the tray is free of debris. b Make sure that the tray is properly installed and aligned to the printer. c Reseat the interface cable that is plugged into the 2500. or 2 x 500.sheet tray. d Reset the printer. Does the problem remain? Go to step 2. The problem is solved. Step 2 a Remove the rear cover. b Make sure that the sensor (3000-sheet tray set) is properly installed. c Make sure that the sensor is free of debris or dust. d Reseat the cable on the sensor and the cable CN5 on the controller board. e Check the sensor for damage. Is it free of damage? Go to step 3. Go to step 4. Step 3 Enter the Diagnostics menu, and then navigate to: SENSOR TESTS > 3000.Sheet Tray Sensor Tests > Tray set Does the sensor status change while toggling the sensor? Go to step 5. Go to step 4. Step 4 Replace the sensor. See gSensor (3000-sheet tray set) removalh. Does the problem remain? Go to step 5. The problem is solved. Step 5 a Reseat the cable on the rest of the sensors. b Reseat the cable CN5 on the controller board. c If necessary, reseat all the junction connectors on the cables. d Make sure that the cables do not block the path of moving parts. e Check the cables for damage, and replace if necessary. Does the problem remain? Go to step 6. The problem is solved. Step 6 a Reseat the cable on all of the motors and on the top door switch. b Reseat the cables CN3 and CN4 on the controller board. c If necessary, reseat all the junction connectors on the cables. d Make sure that the cables do not block the path of moving parts. e Check the cables for damage, and replace if necessary. Does the problem remain? Contact the next level of support. The problem is solved.