Code: 820...824.01
Description: 820 Scanner lamp exposure did not reach the required level 820.01 Scanner lamp exposure went over the required level. 824 The sensor (scanner lamp home) did not detect the scanner lamp at its home position. 824.01 The scanner lamp remains detected at its home position during a scan job.
Remedy: Step 1 Enter the Diagnostics menu, and then navigate to: PRINTER SETUP > Reset Engine Service Error Note: Do this step every time a service error would occur to clear the error and restore the engine settings. Does the error remain? Go to step 2. The problem is solved. Step 2 a Reseat the scanner lamp cable. b Check the cable for damage, and replace if necessary. Does the problem remain? Go to step 3. The problem is solved. Step 3 Check the scanner lamp for damage, and replace if necessary. Does the problem remain? Go to step 4. The problem is solved. Step 4 Check the scanner controller board for damaged pins, and replace if necessary. See “Scanner controller board removal”. Does the problem remain? Go to step 5. The problem is solved. Step 5 Check the engine controller board for damaged pins, and replace if necessary. See “Engine controller board removal”. Does the problem remain? Contact the next level of support. The problem is solved.