Code: 6100
Description: Press/heat roller heating time-out 1
• The temperature on the press/heat roller does not rise within the predetermined period when ASIC (U8) on the engine controller PWB (KP-801) has turned on the lower heater lamp. This is detected when the lower heater lamp is turned on.
• The temperature on the press/heat roller does not rise within the predetermined period when ASIC (U8) on the engine controller PWB (KP-801) has turned on the lower heater lamp. This is detected when the lower heater lamp is turned on.
Causes: Defective engine controller PWB (KP-801). Defective lower heater lamp. Defective lower thermostat. Defective fuser PWB (KP-811). Defective lower fuser thermistor, or fitting is not proper. Defective power supply unit. Defective harness (S02572) between engine controller PWB (KP-801) and fuser unit, or poor contact of the connector terminals.
Remedy: Defective engine controller PWB (KP-801). Replace the engine controller PWB (KP- 801).
Defective lower heater lamp. Replace the fuser unit (lower heater lamp).
Defective lower thermostat. Replace the fuser unit (lower thermostat).
Defective fuser PWB (KP-811). Replace the fuser unit (fuser PWB [KP- 811]).
Defective lower fuser thermistor, or fitting is not proper. Replace the fuser unit (lower fuser thermistor).
Defective power supply unit. Replace the power supply unit.
Defective harness (S02572) between engine controller PWB (KP-801) and fuser unit, or poor contact of the connector terminals. Check the continuity of the harness (S02572). Check the insertion of connectors.
Defective lower heater lamp. Replace the fuser unit (lower heater lamp).
Defective lower thermostat. Replace the fuser unit (lower thermostat).
Defective fuser PWB (KP-811). Replace the fuser unit (fuser PWB [KP- 811]).
Defective lower fuser thermistor, or fitting is not proper. Replace the fuser unit (lower fuser thermistor).
Defective power supply unit. Replace the power supply unit.
Defective harness (S02572) between engine controller PWB (KP-801) and fuser unit, or poor contact of the connector terminals. Check the continuity of the harness (S02572). Check the insertion of connectors.