Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi 6000 — Kyocera FS9520DN

Code: 6000

Description: Broken fuser heater wire
• When the power is turned on or at the start of fuser unit control from the sleep mode, 10 s after fuser heater M is turned on, the detected temperature of fuser unit thermistor 2 is lower than 40 °C/104 °F.
Causes: Poor contact in the fuser unit thermistor 1 or 2 connector terminals. Fuser unit thermistor 1 or 2 installed incorrectly. Fuser unit thermostat triggered. Fuser heater M or S installed incorrectly. Broken fuser heater M or S wire.
Remedy: Check the connection of connector YC10 on the engine controller PWB and the continuity across the connector terminals. Repair or replace if necessary. Check and reinstall if necessary. Check for continuity. If none, replace the fuser unit thermostat. Check and reinstall if necessary. Check for continuity. If none, replace the fuser heater M or S.

← Xem tất cả mã lỗi Kyocera FS9520DN

Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie