Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi 6050 — Kyocera FS9520DN

Code: 6050

Description: Abnormally low fuser unit thermistor temperature
• When only fuser heater M is on, fuser unit thermistor 2 detects temperature lower than 80 °C/176 °F during printing. • When fuser heater M and fuser unit heater S are on, fuser unit thermistor 2 detects temperature lower than 80 °C/176 °F or fuser unit thermistor 1 detects temperature lower than 100 °C/212 °F during ptinting.
Causes: Poor contact in the fuser unit thermistor 1 or 2 connector terminals. Broken fuser unit thermistor 1 or 2 wire. Fuser unit thermistor 1 or 2 installed incorrectly. Fuser unit thermostat triggered. Fuser heater M or S installed incorrectly. Broken fuser heater M or S wire.
Remedy: Check the connection of connector YC10 on the engine controller PWB and the continuity across the connector terminals. Repair or replace if necessary. Measure the resistance. If it is ∞, replace the fuser unit thermistor 1 or 2. Check and reinstall if necessary. Check for continuity. If none, replace the fuser unit thermostat. Check and reinstall if necessary. Check for continuity. If none, replace the fuser heater M or S.

← Xem tất cả mã lỗi Kyocera FS9520DN

Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie