Code: 5301
Description: Broken eraser lamp K wire
When the eraser lamp K is driven, the eraser lamp K over-current detection signal is detected continuously for 10 times (1 s) at 100 ms intervals.
When the eraser lamp K is driven, the eraser lamp K over-current detection signal is detected continuously for 10 times (1 s) at 100 ms intervals.
Causes: Defective harness between drum unit K and drum relay PWB (YC3), or improper connector insertion. Defective harness between drum relay PWB (YC1) and engine PWB (YC34), or improper connector insertion. Defective eraser lamp K. Defective engine PWB.
Remedy: Defective harness between drum unit K and drum relay PWB (YC3), or improper connector insertion. Reinsert the connector. Also check for continuity within the connector harness. If none, remedy or replace the harness.
Defective harness between drum relay PWB (YC1) and engine PWB (YC34), or improper connector insertion. Reinsert the connector. Also check for continuity within the connector harness. If none, remedy or replace the harness.
Defective eraser lamp K. Replace the drum unit K..
Defective engine PWB. Replace the engine PWB.
Defective harness between drum relay PWB (YC1) and engine PWB (YC34), or improper connector insertion. Reinsert the connector. Also check for continuity within the connector harness. If none, remedy or replace the harness.
Defective eraser lamp K. Replace the drum unit K..
Defective engine PWB. Replace the engine PWB.