Code: 6100
Description: Broken fuser heater lamp 2 wire
The detected fuser thermistor 2 temperature does not rise 1°C/1.8°F after the fuser heater lamp 2 has been turned on continuously for 5 seconds in warming up. The detected temperature of fuser thermistor 1 does not reach 80°C/176°F after fuser heater lamp 2 has been turned on continuously for 40 seconds in warming up. The detected temperature of fuser thermistor 1 does not rise 1°C/1.8°F after fuser heater lamp 2 has been turned on continuously for 5 seconds during printing. The detected temperature of fuser thermistor 1 is 100°C/180°F lower than the detected temperature of fuser thermistor 2 continuously for 3 seconds.
The detected fuser thermistor 2 temperature does not rise 1°C/1.8°F after the fuser heater lamp 2 has been turned on continuously for 5 seconds in warming up. The detected temperature of fuser thermistor 1 does not reach 80°C/176°F after fuser heater lamp 2 has been turned on continuously for 40 seconds in warming up. The detected temperature of fuser thermistor 1 does not rise 1°C/1.8°F after fuser heater lamp 2 has been turned on continuously for 5 seconds during printing. The detected temperature of fuser thermistor 1 is 100°C/180°F lower than the detected temperature of fuser thermistor 2 continuously for 3 seconds.
Causes: Defective harness between fuser thermistor 1 and paper exit PWB (YC4), or improper connector insertion. Defective harness between paper exit PWB (YC1) and engine PWB (YC602), or improper connector insertion. Fuser thermistor 1 installed incorrectly. Fuser thermal cutout triggered. Fuser heater lamp 2 installed incorrectly. Broken fuser heater lamp 2 wire. Defective engine PWB.
Remedy: Defective harness between fuser thermistor 1 and paper exit PWB (YC4), or improper connector insertion. Reinsert the connector. Also check for continuity within the connector harness. If none, remedy or replace the harness.
Defective harness between paper exit PWB (YC1) and engine PWB (YC602), or improper connector insertion. Reinsert the connector. Also check for continuity within the connector harness. If none, remedy or replace the harness.
Fuser thermistor 1 installed incorrectly. Replace the fuser unit.
Fuser thermal cutout triggered. Replace the fuser unit.
Fuser heater lamp 2 installed incorrectly. Replace the fuser unit.
Broken fuser heater lamp 2 wire. Replace the fuser unit.
Defective engine PWB. Replace the engine PWB.
Defective harness between paper exit PWB (YC1) and engine PWB (YC602), or improper connector insertion. Reinsert the connector. Also check for continuity within the connector harness. If none, remedy or replace the harness.
Fuser thermistor 1 installed incorrectly. Replace the fuser unit.
Fuser thermal cutout triggered. Replace the fuser unit.
Fuser heater lamp 2 installed incorrectly. Replace the fuser unit.
Broken fuser heater lamp 2 wire. Replace the fuser unit.
Defective engine PWB. Replace the engine PWB.