Code: 6010
Description: Heat roller heating time-out 2
• The temperature on the heat toller does not reach the correct temperature within the predetermined period after self-diagnostic code 6000 is cleared. The period for detection is longer than the condition for selfdiagnostics code 6000.
• The temperature on the heat toller does not reach the correct temperature within the predetermined period after self-diagnostic code 6000 is cleared. The period for detection is longer than the condition for selfdiagnostics code 6000.
Causes: Defective engine controller PWB (KP-992). Defective upper heater lamp. Defective upper thermostat. Defective fuser PWB (KP-997). Defective upper fuser thermistor, or fitting is not proper. Defective AC power source (Abnormal low voltage). Defective harness (2CK2719, 2CK2712) between engine controller PWB (KP-992) and paper feeder/options relay PWB (KP-995) and fuser unit, or poor contact of the connector terminals.
Remedy: Replace the engine controller PWB (KP- 992). Replace the fuser unit (upper heater lamp). Replace the fuser unit (upper thermostat). Replace the fuser unit (fuser PWB [KP- 811]). Replace the fuser unit (upper fuser thermistor). Connect to the proper AC power source. Check the continuity of the harness (2CK2719, 2CK2712). Check the insertion of connectors.