Code: C6200
Description: Broken sub fixing heater connection •Temperature detected by fixing unit thermistor 2 was lower than 100°C after fixing stabilized.
Causes: The sub fixing heater is not installed correctly. The sub fixing heater has a break. Fixing unit thermistor 2 is not installed correctly. Fixing unit thermistor 2 connector terminals are loosely connected. Fixing unit thermistor 2 has a break. The fixing unit thermostat operates. The fixing heater control circuit on the power source PCB is broken. The engine main PCB or the power source PCB is defective.
Remedy: Check and reinstall if necessary. Check for continuity and if none, replace the sub fixing heater. Check and reinstall if necessary. Check the connection of CN2-14 on the engine main PCB and continuity across the terminals. If there is abnormality, remedy or replace. Measure the resistance. If the resistance is ∞Ω, replace fixing unit thermistor 2. Check for continuity. If none, replace the fixing unit thermostat. Run maintenance item U196 by selecting gHEAT2h. If voltage between TB3 and CN2-2 on the power source PCB does not become 100 V AC, replace the PCB. Run maintenance item U196 by selecting gHEAT2h. If CN4-9 on the engine main PCB does not go low, replace the engine main PCB or the power source PCB and check for correct operation.