Code: C6000
Description: Fuser heater lamp break • The fuser temperature does not increase for 40 s after the fuser heaters have been turned on for warming up. • The fuser temperature remains below 50 C/122F for 10 s continuously after the fuser heaters have been turned on during stabilization.
Causes: Installation defectiveness on fuser thermistor M and S. Defective fuser thermostat. Installation defectiveness on fuser heater L, M or S. Broken fuser heater L, M and S wire. Defective engine PWB. Defective AC power source PWB.
Remedy: Installation defectiveness on fuser thermistor M and S. Check the mounting state of the fuser thermistor M and S. If any problem is found, repair it. Defective fuser thermostat. Replace the fuser thermostat. Installation defectiveness on fuser heater L, M or S. Check the mounting state of the fuser thermistor L, M and S. If any problem is found, repair it. Broken fuser heater L, M and S wire. Check for continuity. If none, replace the fuser heater L, M and S. Defective engine PWB. Replace the engine PWB. Defective AC power source PWB. Replace the AC power source PWB.