Code: C0650
Description: Scanner Home Sensor malfunction
• The Scanner Home Sensor fails to detect the Scanner at its home position though the Scanner is so located. • The Scanner Home Sensor fails to detect the Scanner though the motor has been energized to move the Scanner over the maximum distance. • The Scanner Home Sensor detects the Scanner at its home position though the Scanner has moved 5 mm away from the home position.
• The Scanner Home Sensor fails to detect the Scanner at its home position though the Scanner is so located. • The Scanner Home Sensor fails to detect the Scanner though the motor has been energized to move the Scanner over the maximum distance. • The Scanner Home Sensor detects the Scanner at its home position though the Scanner has moved 5 mm away from the home position.
Remedy: 1 Scanner can be moved manually. NO: Correct drive coupling (Scanner Belt tension, pulley operation, drive cable tension) 2 Scan motion: initial scan motion after the Power Switch has been turned ON or Front Door has been opened and closed. NO: Carry out misfeed/malfunction troubleshooting procedures. 3 Connectors are connected properly on Scanner Motor Drive Board: PWB-IC PJ1IC, PJ2IC, and PJ3IC. NO: Check connectors for connection. 4 Scanner Motor turns when the Start key is pressed. NO: Check connectors for connection. Change motor. Change Scanner Motor Drive Board. 5 I/O check for Scanner Home Sensor: the voltage across PJ6C-2 on Image Processing Board and GND is DC 0 V (home position) when the sensor is blocked and DC 5 V when the sensor is unblocked. YES: Change Image Processing Board. NO: Check sensor for installation. Correct detecting plate. Check sensor connector for connection. Change sensor. 6 “IR Area” check: Malfunction when Power Switch is turned ON after “Top Image” has been set to 0 and “FD-Mag.” to 1.000. NO: Adjust “IR Area” data.