Code: C0660
Description: Scanner overrun failure
The Scanner Home Sensor detects the Scanner at its home position during a period from when the prescan command and scan preparation command have been executed to when home return command is executed.
The Scanner Home Sensor detects the Scanner at its home position during a period from when the prescan command and scan preparation command have been executed to when home return command is executed.
Remedy: 1 Scanner can be moved manually. NO: Correct drive coupling (Scanner Belt tension, pulley operation, drive cable tension) 2 Scan motion: initial scan motion after the Power Switch has been turned ON or Front Door has been opened and closed. NO: Carry out misfeed/malfunction troubleshooting procedures. 3 Connectors are connected properly on Scanner Motor Drive Board: PWB-IC PJ1IC, PJ2IC, and PJ3IC. NO: Check connectors for connection. 4 Scanner Motor turns when the Start key is pressed. NO: Check connectors for connection. Change motor. Change Scanner Motor Drive Board. 5 I/O check for Scanner Home Sensor: the voltage across PJ6C-2 on Image Processing Board and GND is DC 0 V (home position) when the sensor is blocked and DC 5 V when the sensor is unblocked. YES: Change Image Processing Board. NO: Check sensor for installation. Correct detecting plate. Check sensor connector for connection. Change sensor. 6 “IR Area” check: Malfunction when Power Switch is turned ON after “Top Image” has been set to 0 and “FD-Mag.” to 1.000. NO: Adjust “IR Area” data.