Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi 9180 — Kyocera TASKalfa 350ci

Code: 9180

Description: DP switchback motor error When the home position was not detected even if the processing was retried 3 consecutive times. Home position detection: When the home position is not detected by driving one rotation of the DP switchback motor.
Causes:
Remedy: DP switchback motor 1. Unplug the power cord from the wall outlet, and wait five seconds. Then plug the power cord and then turn on the power switch. 2. Confirm that the connector of the switchback motor is firmly connected, and if necessary, push the unit all the way in. 3. Confirm that the wiring connector is firmly connected, and if necessary, connect the connector all the way in. DP switchback motor and DP main PWB (YC2) DP main PWB (YC1) and Main/Engine PWB (YC2) 4. If the wire is disconnected, short-circuited or has ground fault, or the connector pin is deformed, replace the wire. 5. Replace the DP switchback motor. DP switchback sensor 1. Rotate the switchback motor by hand to check that it is not unusually difficult to rotate. 2. Check that the DP switchback sensor is not disengaged and is correctly positioned. And check that the actuator correctly blocks the light. 3. Confirm that the wiring connector is firmly connected, and if necessary, connect the connector all the way in. DP switchback sensor and Main/Engine PWB (YC18) 4. If the wiring is disconnected, short-circuited or has ground fault, replace the wire. 5. DP switchback sensor (DPSBS) Main/Engine PWB 1. Check the engine firmware and upgrade to the latest version if necessary. 2. Replace the Main/Engine PWB.

← Xem tất cả mã lỗi Kyocera TASKalfa 350ci

Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie