Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi 6200 — Kyocera TASKalfa 3510i

Code: 6200

Description: Broken fuser edge heater wire
Even if 60 seconds pass after a warm-up start, when it will not be in a stable state. When the difference in temperature 5.6 seconds and 16 seconds after heater lighting is less than 43 °C. Even if 8 seconds pass during test mode operation, when change of AD is less than three.
Causes: Fuser unit. Fuser thermostat. Fuser heater. Powe source PWB. Engine PWB.
Remedy: Fuser unit 1. Confirm that the wiring connector is firmly connected and, if necessary, connect the connector all the way in. Power source PWB (YC6) and Engine PWB (YC24) 2. If the wiring is disconnected, shorted or grounded, replace the wiring. 3. If the I/F connector pins of the fuser unit and the main unit are deformed owing to foreign matters, such as paper dusts, replace the connectors or the units including the connectors.
Fuser thermostat. Fuser heater. Replace the Fuser unit.
Powe source PWB Replace the power source PWB.
Engine PWB 1. Check the engine software and upgrade to the latest, if necessary. 2. Replace the engine PWB.

← Xem tất cả mã lỗi Kyocera TASKalfa 3510i

Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie