Code: 6200
Description: Broken fuser edge heater wire Even if 50 seconds pass after a warm-up start, when it will not be in a stable state. When the difference in temperature 4 seconds and 12 seconds after heater lighting is less than 45 °C. Even if 8 seconds pass during test mode operation, when change of AD is less than three.
Causes: Fuser unit. Fuser thermostat. Fuser heater. Powe source PWB. Engine PWB
Remedy: Fuser unit 1. Confirm that the wiring connector is firmly connected and, if necessary, connect the connector all the way in. Power source PWB (YC7) and Engine PWB (YC10) 2. If the wiring is disconnected, shorted or grounded, replace the wiring. 3. If the I/F connector pins of the fuser unit and the main unit are deformed owing to foreign matters, such as paper dusts, replace the connectors or the units including the connectors.
Fuser thermostat Fuser heater. Replace the Fuser unit.
Powe source PWB Replace the power source PWB.
Engine PWB Replace the engine PWB.
Fuser thermostat Fuser heater. Replace the Fuser unit.
Powe source PWB Replace the power source PWB.
Engine PWB Replace the engine PWB.