Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi 8420 — Kyocera TASKalfa 356ci

Code: 8420

Description: Punch slide motor error 2 During paper edge detection, in case a paper edge cannot be detected even when the paper moves 60mm (35/40 ppm model only)
Remedy: Punch slide motor 1. Execute [Motor] > [Punch Move] in U240 Checking the operation of the finisher. 2. The punch slide section of the punch unit moves back and forth manually without being caught. 3. Check if the motor drive is delivered to the punch section. 4. Confirm that the wiring connector is firmly connected, and if necessary, connect the connector all the way in. Punch slide motor - Punch PWB(YC3) 5. If the wiring is disconnected, short-circuited or has a ground fault, replace the wire. 6. Replace the punch slide motor.
Punch paper edge sensor 1,2 1. Execute [Punch] > [Edge] Face1,2,3,4 in U241 Checking the operation of the finisher switch. 2. Check if there is a failure in the position of the sensor or mounting plate. 3. Confirm that the wiring connector is firmly connected, and if necessary, connect the connector all the way in. Punch paper edge sensor 1,2 - Punch PWB (YC8,YC5) 4. Replace the punch paper edge sensor 1,2.
Punch unit PWB 1. Confirm that the wiring connector is firmly connected, and if necessary, connect the connector all the way in. Punch PWB - DF main PWB (YC7) 2. Replace the Punch PWB.
DF main PWB Replace the DF main PWB.

← Xem tất cả mã lỗi Kyocera TASKalfa 356ci

Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie