Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi E030 — Kyocera TASKalfa 650c

Code: E030

Description: Power-ON jam: The paper is remaining on the paper transport path when power is turned ON.
Remedy: E030] Power-ON jam 1. Open the cover of the unit/area whose picture is flashing on the control panel and remove if there is any paper on the transport path. (Refer to the table below.) 2. Is the sensor in the jamming area working? (Perform the input check: Refer to the following table.) 3. Check if the connector on the PFC board is disconnected from the corresponding sensor in the jamming area or the harnesses are open circuited. Correct if any. 4. Replace the sensor. 5. Replace the PFC board. Relation between the jamming area and the corresponding sensors/covers. (If a jam is occurring in the ADU or LCF check the board in each unit.)
Registration area paper feed cover Registration sensor 03-[FAX]OFF/[7]/[F] Paper clinging detection sensor 03-[FAX]OFF/[7]/[E] 1st drawer feed sensor 03-[FAX]ON/[1]/[G] Exit area Fuser cover Exit sensor 03-[FAX]ON/[1]/[B] ADU ADU ADU entrance sensor 03-[FAX]ON/[4]/[B] ADU exit sensor 03-[FAX]ON/[4]/[A] Feeding area (equipment) paper feed cover 2nd drawer feed sensor 03-[FAX]ON/[1]/[F] 3rd drawer feed sensor 03-[FAX]OFF/[2]/[D] 4th drawer feed sensor 03-[FAX]OFF/[8]/[D] Bypass unit Bypass unit Bypass feed sensor 03-[FAX]ON/[4]/[D] LCF LCF side cover LCF feed sensor 03-[FAX]OFF/[0]/[G] Bridge unit Bridge unit Bridge unit transport sensor-1 (Entrance sensor) 03-[FAX]OFF/[5]/[F] Bridge unit transport sensor-2 (Exit sensor) 03-[FAX]OFF/[5]/[D]

← Xem tất cả mã lỗi Kyocera TASKalfa 650c

Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie