Description: Jam not reaching the original reading end sensor
Remedy: 1. Check the RADF position adjustment. "3.8.1 RADF position adjustment" 2. Check the Adjustment of the Reversing Automatic Document Feeder (RADF). "3.8 Adjustment of the Reversing Automatic Document Feeder (RADF)" 3. Clean the read end roller if it is stained. 4. Is the reading end sensor working? (Perform the input check: 03-[FAX]ON/[5]/[D]) * If it is working properly, proceed to 6. If not, check 3 to 5 below. 5. Check if the connector CN75 on the RADF board is disconnected from the read end sensor or the harnesses are open-circuited. Correct if this is the case. 6. Replace the original reading end sensor. 7. Replace the RADF board, and then perform the automatic adjustment for the original reading start sensor (05-356). 8. Replace the reading end roller, if it is worn out.