Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi C6000 — Kyocera TASKalfa 820

Code: C6000

Description: Fuser heater lamp break
• The fuser temperature does not increase for 40 s after the fuser heaters have been turned on for warming up.
• The fuser temperature remains below 50C/122F for 10 s continuously after the fuser heaters have been turned on during stabilization.
Causes: Installation defectiveness on fuser thermistor M and S.
Defective fuser thermostat 1 or 2.
Installation defectiveness on fuser heater L, M or S.
Broken fuser heater L, M and S wire.
Defective engine PWB
Defective AC power source PWB.
Remedy: Installation defectiveness on fuser thermistor M and S. Check the mounting state of the fuser thermistor M and S. If any problem is found, repair it.
Defective fuser thermostat 1 or 2. Replace the fuser thermostat 1 or 2.
Installation defectiveness on fuser heater L, M or S. Check the mounting state of the fuser thermistor L, M and S. If any problem is found, repair it.
Broken fuser heater L, M and S wire. Check for continuity. If none, replace the fuser heater L, M and S.
Defective engine PWB. Replace the engine PWB.
Defective AC power source PWB. Replace the AC power source PWB.

← Xem tất cả mã lỗi Kyocera TASKalfa 820

Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie