Code: SC510
Description: Paper feed motor error - Timing & Condition - • The feedback signal from the motor is still out of range 1 second after the trigger signal is sent. • The feedback signal becomes out of range for 2 seconds while the trigger signal is on
Causes: • Poor connection of connector • Defective paper feed motor • Defective I/O control board • Defective main control board • Mechanical overload
Remedy: 1. Check if the connector is properly connected on the I/O control board (CN224). 2. Replace the paper feed motor. (Output check: SP 5- 804-08 to 09) 3. Replace the I/O control board. 4. Replace the main control board. 5. Check the feed unit drive section and if anything causes overload. - Signals to Check - • Motor OK: CN224-B4 or TP297 on I/O control board